Dust-Catching Filter - One-Step Application, One-Size-Fits-All 2.4m

4901987254577

B0FH1DP9VY

74944-001

Ventilation Fan Filter - Dust-Catching Filter - Approx. 45cm x 2-4m - Cuts into 48 pieces of 15cm - S5457
【 Purpose 】\
This product catches dust and pollen accumulating in the following equipment and locations to prevent dirt buildup. (Toilet/Changing Room/Bathroom Ventilation Fans, Room Vents, Air Conditioners, Bathroom Dryers, Bathroom Doors)\
\
【 Compatible Models 】\
〔Toilet, Changing Room, Bathroom Ventilation Fans〕\
○: Models with a front cover Square Round\
×: Models with exposed blades\
〔Bathroom Doors〕\
○: Swing door type (door type), folding door type\
×: ・Other types not listed above ・Unpainted aluminum doors\
〔Bathroom Dryers〕\
○: Bathroom dryers installed on the ceiling where the air intake (air inlet) is visible\
×: ・Wall-mounted bathroom dryers ・ Far-infrared heater type ・Halogen heater type ・Cannot be used on types where the intake section is not visible.\
〔Room Ventilation Grilles (Indoor Type)〕\
○: Round Square\
×: Round with cover Square push-type Front cover type ・Cannot be installed on types other than the above or on ventilation grilles without space for a filter.\
〔Air Conditioner〕\
○: ・Top intake type (Type where built-in filter is not exposed) ・Front air intake type\
×: ・Top air intake type (Type where built-in filter is exposed) ・Front panel auto-open/close type The filter may detach when the auto-cleaning function operates.\
Do not use on the following models as adhesive residue or paint may peel off. \
・Air conditioners with patterned designs like colored or woodgrain finishes\
・Air conditioners with pearl or glitter finishes that change color depending on viewing angle\
【 Usage Instructions 】\
(Check before installation.)\
Do not install if the unit is dirty or wet. Wipe off any dirt thoroughly and install only when dry. For air conditioners, wash and dry the included filter before installation.\
1. Cut the filter with scissors\
Cut it slightly larger than the ventilation area. The larger cut area acts as an “adhesive overlap,” making it less likely to peel off. Aim for at least 2cm per side.\
The transparent film has measurement lines as a cutting guide. 1 square = 1cm\
※When cutting into a circle, use the lines as a reference to cut round.\
2. Peel off the transparent film and apply\
Peel off the transparent film and attach it to the unit.\
○ Key Tips\
To ensure the filter adheres firmly and stays put:\
(1) Smooth out any wrinkles or creases in the filter before installation.\
(2) Press down firmly on the “adhesive overlap” area with your hand as you apply it.\
(3) Cut the adhesive area so the larger portion aligns with the “adhesive overlap” around the ventilation opening, as shown below. \
*When cutting to a 20cm square, start cutting from either the top or bottom edge.\
【 Important Precautions 】\
▪️Do not use on exhaust vents of kitchen range hoods, range hoods, gas water heaters, or outdoor ventilation openings.\
▪️Installation may not be possible depending on the size and shape of the appliance. Read the package instructions carefully before use. Also, it cannot be installed on models with an embossed surface.\
▪️Replace promptly when the replacement indicator appears. Continued use with a dirty filter may cause clogging and reduce appliance performance.\
▪️If the replacement indicator does not function properly...

127x31x501 mm

90 g