I Live Auto Flashing Type [Auto Tail Light] Equipped with Illuminance & Vibration Dual Sensors

4571419610297

B00LIRG0Z8

00144210

I live - Auto Flashing Type Auto Tail Light with Dual Vibration Sensors. A unique frog-themed cycling accessory. The I live classic Auto Tail Light was redesigned in the spring of 2016. The flashing and turning-off programs have been revised, improving visibility and safety. "I live took this seriously." says I live, their first serious cycling accessory. This fully automatic tail light flashes without any button operation, ensuring you'll never forget to turn it on or off, while also conserving battery life. Two AAA alkaline batteries provide approximately 200 hours of flashing. An ambient light sensor detects ambient brightness and stops flashing during the day. Flashing automatically starts when entering a dark area, such as a tunnel. It also features a vibration sensor, so flashing automatically stops when parked at night. Its 40-60-second afterglow makes it stand out even when stopped at a traffic light. Once the flashing starts, it will remain in flashing mode for several minutes, providing peace of mind when walking through well-lit areas at night, such as shopping districts. A forced-off button is also included for when flashing is not needed. The included brackets make attaching and detaching the light easy. One is for seat posts, and two (two sizes) are for seat rails. Equipped with three high-brightness LEDs and two chip-on-board LEDs, this is a serious auto tail light boasting exceptional brightness. *How to install vertically on a seat post: To install the auto tail light vertically on a seat post, remove the vertical base from the included seat rail bracket and replace it with the horizontal base from the seat post bracket. Use the longer bolts for the seat post bracket. Please note that due to the bracket's structure, the tail light cannot be installed centered on the seat post (vehicle). Brand name: I live Main unit, various brackets, 2 AAA batteries for testing Material: Plastic Country of origin: China Size: (approx.) Width 102mm x Depth 35mm x Thickness 25mm *Main unit only. Weight (excluding accessories): Approx. 31g (excluding batteries) Power Source: Two AAA alkaline batteries (two included for the monitor) Light Source: Three high-brightness red LEDs, two chip-onboard LEDs Lighting Pattern: Full-auto flashing only (Equipped with a forced-OFF switch) Wide light distribution and vibration sensor Battery Life: Approx. 100 hours (using alkaline batteries) Mounting Diameter: Seatpost φ25.4-31.6mm / Seatstay φ12-15mm, φ19-23mm (Vertical or horizontal mounting possible by rearranging the brackets) Accessories: Two alkaline batteries (for the monitor), one seatpost bracket set (with rubber band, horizontal mounting), seatstay bracket set (for φ12-15mm, with rubber band, vertical mounting), seatstay holder (for φ19-23mm with rubber band), instruction manual (The included batteries are for the monitor. The usage time may differ from the specified time. Be careful not to confuse the + and - terminals when installing the batteries. Operate the switch only when the bicycle is stopped. To prevent malfunctions, clean the battery contacts regularly. This product is not completely waterproof. To prevent malfunctions, wipe off moisture thoroughly after use in the rain. The small hole on the side of the main body is an air vent to prevent condensation. Please do not block it (water rarely gets in through the air vent). When replacing the battery, follow the battery usage instructions. Do not mix old and new batteries or different types of batteries. Make sure the light is securely fastened before riding. *Product color may differ from the actual product depending on the display type. *Please note that the specifications, logo, and design of the product may be changed for improvement purposes. 4571419610297 I live Auto Flashing Type [Auto Tail Light] Equipped with Light and Vibration Dual Sensors (text created at , 2025-07-01)

110x56x160 mm

170 g